The overload indicator can also be reset with a key command now.
It is reset by clicking on it or whenever the engine is reinitialized due to audio device setting changes or when the reset button is pressed. For example, this might occur if the prefetch (ASIO-Guard) buffer runs empty due to a too high real-time load. The processing overload indicator at the right indicates dropouts if the processing load exceeds 100% or if the audio engine is restarted due to the internal detection of too high processing delays. I plugin the XLR for the mic into that channel and it gets worse. I plug the Lexicon in and turn up the line 2/mic channel, I hear a faint high pitch ring. I have the Lexicon Alpha, Cubase LE5 that came with it, and a dynamic mic. The metering of the current disk engine load is identical to the one used in previous releases. Hello, Ive recently purchased some cheap budget recording equipment just to lay down some demos and what not. If this meter peaks/clips, it will cause an audio dropout (see below). Shows the highest measured load (in the latency critical real-time processing path). If the audio interface is set to a small block size, it is a bigger block size than for real-time processing. The amp is normal until I open Cubase 10.
#CUBASE 10 PRO ZE HIGH PITCH NOISE WINDOWS#
The block size depends on the ASIO-Guard settings found on the 'Audio System' page of the 'Studio Setup' dialog. I am also having a high pitched tube amp noise when using Cubase 10 and Windows 10. Shows the average audio processing load of the processing path, which can be processed in advance (prefetched). It is always processed with the block size of the audio device settings. This is the case for all live inputs or monitoring activated channels. Show the average audio processing load of the latency critical processing path. Often, this needs to be investigated further. No problem with using the on-board headphone outputs, but the moment any copper connection to an un-balanced audio amp, then back came the noise again. One example could be plug-ins which create a sporadic high peak load or which have an issue that directly affects the engine performance. Whenever using analogue outputs, I would get horrible high-pitched computer whining and gurgling noises - all the time. The purpose of the distinction between real-time (average) and real-time (peak) is to identify issues which are caused by a high deviation between average and real-time. This not only offers a quick overview of the overall system load, but also provides a detailed indication of the source of the current system load. The metering toolbar displays the current real-time, ASIO-Guard and peak loads. To achieve this, a new algorithm to separately measure the load for real-time and prefetch (ASIO-Guard) threads has been implemented. The purpose of the new Audio Performance Meter is to give you a more detailed feedback on the audio engine load situation and to allow for a quick diagnosis of audio engine issues.
0 kommentar(er)
